广州森辰驰机械设备有限公司

①     主机启动 the host start button

②     电源指示灯 power light

③     水泵启动 water pump start button

④     水泵停止water pump stop button

⑤     主机停止 the host stop button

⑥     紧急停止 emergency stop button

⑦     石料紧固装置 stone fastening device

⑧     左右控制手轮 about control handwheel

⑨     石料卡紧螺杆 stone lock screw

⑩     档杆 gear lever

＆#9322;     主轴 principal axis

＆#9323;     调速开关 speed-control switch

＆#9324;      进料螺杆挂档 feed screw

＆#9325;      油泵 oil pump

＆#9326;      油箱 oil tank

品 名：单刀片自动油切机

参 数：

输入电压：AC 380V

电机功率：4KW

主轴转速：1250r/min

外观尺寸：长130cm×宽85cm×高130cm（±5cm）

 

Name：Oil cutting machine

Arguments：

U：AC 380V

P：4KW

Rev：1250r/min

Size: 130cm (L)×85cm (W)×130cm (H)（±5cm）

 

1.      the blade is arranged on ＆#9322;principal axis, and lock;

2.      Put the white mineral oil into ＆#9326;oil tank, along the tank edge 5cm;Put the oil pump on the tank above (must not directly put the oil pump into the tank!!!);

3.      Put the gem stone in ⑦the stone fastening device, lock ⑨the stone clamping screw;

4.      According to your own needs, adjust ⑧about control handwheel, to adjust the material thickness;

5.      Open ＆#9325;the pump switch;

6.      Start ①the host stop button;

7.      Open＆#9323;the speed switch, according to stone hardness adjusting feeding speed (stone more soft, feed more rapidly; stone is hard, feed more slowly);

8.      When faced with an emergency, press ⑥emergency stop button, check the machine;

9.      ＆#9324;feed screw (pushing is putting into gear, screw rotation, stone forward; pull-out is block, while rotating the handwheel, the stone can be backward or forward);

10. ⑩the gear lever (red shift lever to the right, can push stone, move back and forth; gear lever back is gear, automatic feed).

11. The tank at the bottom of many stone slag deposition, after cleaning, oil can be recycled.